Available in three sizes and made from 190 micron ‘mylar A’ flexible recyclable material to transform the look of old wall and floor tiles, both in the home and in the garden. Old paving slabs can get a new lease of life, using paint and this stencil, prepare the surface, take you time when stenciling and seal the pain when it’s dry. The results are so effective and satisfying, you’ll be proud to show off your handywork!

Application :- 1) Use on clean painted walls or over existing flat wall and floor tiles, paving slabs or paths should be jet washed and left to dry out completely before application 2) Use a coat of primer to create a nice even base for painting, leave for 24 hours to dry fully 3) Use a brush or small foam roller to apply sparingly over your tile stencil with your chosen paint, do not overload with paint, this will cause bleeding 4) When stenciling floors, start at the furthest point from the door to avoid stepping on your freshly painted floor 5) Clean the stencil between uses to remove paint and prevent blotting (two stencils can be used to speed up the process) 6) Use masking tape to hold the stencil in place while you’re painting 7) A fine paint brush can be used to touch up any bleeds or jagged lines 8) Seal your work to protect using a good quality clear water based polyurethan varnish for indoors and patio and paving seal for outdoors

Aftercare :- 1) Clean with a non-abrasive household cleaner and water to remove water-based paint. These stencils can be re-used if cleaned properly